Connection Illustration - ClickTronic HC 414 Notice D'utilisation

No sound:
• Check all plug-in connections.
• Check the connecting lines. Is any line damaged? Are the lines
suitable for audio and video transmission?
• It might be required to reset the switch. Turn off the HC 414 by
using the main switch on the rear side of the device, unplug
the power supply and wait about 5 minutes. Then restart the device
as previously described in this manual.
• Is there a video recording device connected to one of the outputs?
In this case HDCP automatically blocks the sound signal
transmission.

Connection Illustration

All names of companies and products are trademarks of the respective owner. All rights
reserved. HDMI is a registered trademark of the HDMI Licensing L.L.C
wentronic Electronic Components Handels GmbH hereby declares that Article No. 60806
complies with the basic requirements and other relevant regulations of directives 89/336/
EWG, 2004/108/EC and 73/23/EWG.
8