Hilti CD 4-­A22 Mode D'emploi Original page 13

3. Use an approved charger to charge the battery.
5.1.2 Inserting the battery
CAUTION
Risk of injury by short circuit or falling battery!
▶ Before inserting the battery, make sure that the contacts on the battery and the contacts on the product
are free of foreign matter.
▶ Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
2. Push the battery into the battery holder until it engages with an audible click.
3. Check that the battery is seated securely.
5.1.3 Removing the battery
1. Press the battery release buttons.
2. Remove the battery from the tool.
5.2 Installing the scaffold hook (accessory)
▶ Install the scaffold hook.
5.3 Preassembly of cartridge holder for cartridges
1. Hold the release button pressed.
2. Guide the appropriate (short) piston rod into the power tool so that the toothing is at the bottom.
3. Position the grip at the rear on the piston rod and fix it in place with the screw.
4. Screw the cartridge holder onto the connecting sleeve.
5.4 Preassembly of aluminum tube for foil packs and cartridges
1. Hold the release button pressed.
2. Guide the appropriate (long) piston rod into the power tool so that the toothing is at the bottom.
3. Position the grip at the rear on the piston rod and fix it in place with the screw.
Make sure that the piston attachment for foil packs is mounted on the piston rod.
4. Screw the cartridge holder onto the connecting sleeve.
When preparing the cartridges with the aluminum tube, it is essential that piston attachment for
foil packs is removed again, as otherwise the cartridge will be damaged.
5.5 Inserting the cartridge
1. Press the release button.
2. Pull the piston rod back as far as they will go.
3. Open the cartridge with the aid of a cutter knife.
4. Mount the included nozzle.
5. Insert the cartridge with the base facing the piston into the cartridge holder and tilt the cartridge downward
until the front section is locked in position.
6. Manually push the piston rod forward to ensure that the cartridge is well-seated.
5.6 Inserting foil pack
1. Press the release button.
Make sure that the piston attachment for processing foil packs is screwed onto the piston rod
2. Pull the piston rod back as far as they will go.
3. Unscrew the front panel.
4. Open the foil pack with the aid of a suitable tool and insert the foil pack.
5. Mount the cover provided with the foil pack including the nozzle.
*2221133*
Printed: 29.07.2019 | Doc-Nr: PUB / 5466599 / 000 / 02
6
4
5
2221133
2
3
English 7