Cleaning And Maintenance - tomado TDW6001W Manuel D'utilisation

1. Push the start/pause button to pause the program.
2. Push and hold the program selector button for 3 seconds to start the program selection mode.
3. Push the program selector button to change the program.
4. Push the start/pause button to start the selected program.
The newly selected program will resume the course of the previously selected program.
DELAYING THE PROGRAM
Note:
The start time of a program can be delayed for 2, 4, 6, or 8 hours.
1. Push the timer button to delay the start time of a program. Every time you push the button the indicator for the next delay
interval goes on.
2. Push the timer button again to increase the delay of the start time or to cancel the timer.
3. Close the door.
4. Push the start/pause button.
The program will start when the timer has finished.
STOPPING THE APPLIANCE
Note:
The appliance is silent for 40 to 45 minutes during the drying process.
Note:
A buzzer sounds five times when the program is finished.
1. Open the door.
2. Wait a few minutes before you unload the appliance. The dishes are very hot and can break.
3. Push the on/off button to switch off the appliance.
7

Cleaning and maintenance

CLEANING THE APPLIANCE
Caution:
Make sure that the appliance is off.
Note:
If you clean the appliance regularly, it will improve the service life.
1. Clean the outside of the appliance. Use a damp cloth.
2. Clean the seals of the door. Use a soft cloth.
3. Clean the inside of the appliance in case of high contamination:
a. Fill the detergent reservoir with a special cleaning agent for dishwashers.
b. Select a program with a high temperature.
c. Start the program.
CLEANING THE FILTERS
The filter system of the appliance consists of three components: the main filter, the micro filter and the sieve.
Clean the filters weekly.
English • 43