Electrical Connection - tomado TDW6001W Manuel D'utilisation

• Make sure that you connect the water inlet hose directly to the water
tap. The pressure of the water tap must be a minimum of 0,03 MPa
and a maximum of 1 MPa. Install a pressure relief valve if the pressure
is more than 1 MPa.
• After connecting the appliance, open the water tap completely and do
a check for leaks.
• The appliance is supplied with a double-walled aquastop. The system
automatically cuts off the water supply if the water inlet hose is
leaking and the space between the walls is filled with water. Do not
cut into the aquastop and make sure that the aquastop does not get
twisted or stuck.
• Do not use a drain hose that is longer than 4 meter. As a result, dishes
can remain dirty. The manufacturer will not accept responsibility.
• The water drain hose can be connected either directly to a drain pipe
with a minimum diameter of 4 cm, or let the hose run into the sink,
making sure to avoid bending or crimping it. The free end of the hose
must be at a height between 40 and 100 cm and must not be
immersed in water.
• The appliance must be connected to the water mains using the newly
supplied hose sets. Do not reuse old hose sets.

ELECTRICAL CONNECTION

• Make sure that the mains plug of the appliance is connected to a
grounded mains socket. The manufacturer is not responsible for
damage resulting from using the appliance with a mains socket that is
not grounded.
• Make sure that the voltage and the frequency values for the current
correspond to the values of the rating plate.
• The electrical system in your home must be supplied with a 16 Amp
fuse. The appliance is designed for connecting to 220-240 V ~50Hz.
• Do not connect the appliance during placement.
• Use the provided mains plug.
English • 31