Bosch DiBos 8 Recovery EMEA Manuel D'utilisation page 31

DiBos 8 Recovery
12. Click Yes. The recovery procedure takes about 20 minutes.
13. Remove the Recovery DVD in the drive, and then click
14. In the Plug and Play hardware dialog box, where a restart
15. In the dialog box for date and time properties, first select
16. Enter the network settings you wrote down before.
17. Enter the computer name and the workgroup you wrote
18. Restart the computer. The Restore Configuration dialog
Load
Bosch Sicherheitssysteme GmbH
The Reboot dialog box appears when the recovery
procedure is finished.
Reboot. This action starts the computer in Administrator
mode. A dialog box appears if the computer finds any Plug
and Play hardware and another dialog box appears for date
and time properties.
is offered, click No.
the time zone and the Automatically adjust clock for
daylight saving changes check box. Then enter date and
time. Click OK.
– Click Start, click Control Panel, and then double-click
Network Connections.
– Double-click the Local Area Connection icon, click the
General tab, and then click Properties.
– Double-click Internet Protocol (TCP/IP).
– Click the General tab, and then enter the settings.
– Click OK, click OK again and then click Close.
down before.
– In the Network Connections window, click Control
Panel.
– Double-click the System icon, and then click the
Computer Name tab.
– Enter the full computer name and the workgroup.
– Click OK, and then close the Control Panel window.
box appears.
Shows a dialog box to load the saved configuration.
Installation Guide
The Recovery Procedure | en
F.01U.076.408 | V1 | 2007.11
31