Staba AW 210 Pure Mode D'emploi page 15

Timer
∙ By pressing the button you can set the timer in steps of 1 – 3 – 5 – 8 – 10 hours.
∙ The remaining time is shown in the display.
∙ The setting of the time is independent of other functions. If the timer runs out the
device turns off, regardless of the other settings.
∙ In order to turn off the timer, press the button
disappears.
Ventilation
∙ By pressing this button you can set the speed of the ventilation.
∙ If the device is started with the on/off button it starts in the standard mode with
high ventilation speed. The mode is deleted by changing the ventilation speed.
∙ Low: low speed. The humidity is shown in the display.
∙ High: high speed. The humidity is shown in the display.
Water preheating
∙ The water preheating is always turned on in the standard mode.
∙ To turn on/off the water preheating, press this button.
Ionisation
By pressing the button
The purified air will be enriched with negative ions. This creates an effect like after
a summer thunderstorm.
Child lock
Press the button
locked. To deactivate the child lock, press this button again for longer than 3 seconds.
Water level
∙ The device beeps and the symbol blinks in the display if the water level is too low.
∙ After the 3 beep, the water preheating turns off and the ventilation stops after
rd
30 seconds.
∙ To continue the program, refill the water tank and press the on/off button.
Memory
∙ If the device is started with the on/off button, it starts with the last used settings.
∙ If the device is unplugged, it starts with the standard mode.
you can turn on the ionisation.
longer than 3 seconds. All buttons, except the on/off button, are
until the symbol in the display
15