Kenmore 461.91416 Guide D'utilisation page 10

Occasionally, a problem is minor and a service call may not be necessary- use this troubleshooting guide for a
possible solution. If the unit continues to operate improperly, call an authorized service depot or Danby's Toll
Free Number 1-800-263-2629 for assistance.
PROBLEM
1) Unit does not work
2) Unit runs continuously
3) Internal temperature not
cold enough.
4) Ice formation on the
inner rear wall
5) Water is leaking from the
refrigerator
6) Noise
TROUBLESHOOTING
POSSIBLE CAUSE
• No power to unit.
• Power cord unplugged.
• Wrong voltage being used.
• Temperature set too cold.
• Door is not closed.
• Hot food has been inserted.
• Door open too long/too often.
• Close proximity to heat source or direct
sunlight.
• No power to unit.
• Power cord unplugged.
• Temperature control too warm.
• Door open too long/too often.
• Hot food inserted.
• Air flow obstruction.
• Wrong voltage being used.
• Close proximity to heat source or direct
sunlight.
• The door does not seal well
• The door is frequently opened or left too
long
• The food stored in the refrigerator was
warm;
• The food or dish is touching the inner back
wall.
• Water outlet is cloggedso
defrost water drips over the channel
• Appliance not level.
• Appliance not installed on a firm solid
base/floor
• Appliance is touching a wall or other kitchen
units standing next to it.
• Accessories inside the appliance are
placed incorrectly. Bottles tins and other
containers may be touching each other
causing rattling and/or vibrations.
• Check connection of power cord to power
source.
• Plug in unit.
• Use proper voltage.
• Reduce temperature settings.
• Close door securely.
• Ensure food is room temperature before
insterting.
• Reduce frequency and duration of door
openings.
• Do not place unit close to heat sources or
direct sunlight.
• Check connection of power cord.
• Plug in unit.
• Check settings, adjust if necessary.
• Reduce frequency and duration of door
openings.
• Ensure food is room temperature before
inserting.
• Allow room for air to circulate around the unit.
• Use proper voltage.
• Do not place unit close to heat sources or direct
sunlight.
• Set the thermostat knob to STOP (0) position and
leave the door open. Never use electric devices for
defrosting and do not scrape the ice or frost
layer with sharp objects. After defrosting is
complete, turn the knob to desired position and
close the refrigerator door.
• Clean the gasket if it is contaminated, or replace
it if it is damaged.
• Clean the clogged outlet, for example with a
plastic straw.
• Manually defrost the increased ice layer. See "Ice
formation on the inner wall"
• Always make sure that the appliance is
level and installed on a firm solid base/floor.
• The Appliance must not touch any wall or other
kitchen units.
• Make sure the accessories inside the
appliance are correctly placed so they dont
touch each other and cause rattling and/or
vibrations.
9
SOLUTION