Overview Of The Components / Delivery Scope; Unpacking The Device; Notes On Use; Multifunction Button - Clatronic BS 1307 A Mode D'emploi

CAUTION:
• The ambient temperature should be between 0 °C and max. 45 °C.
Heat damages the rechargeable battery. Increasingly lower tem-
peratures reduce the capacity and the life of the rechargeable
battery.
• Do not charge the rechargeable battery unsupervised.
• Use only the mains adapter "ZD12D265050EU" included in the
scope of deliveries.
• Disconnect the power supply unit from the mains when you will
not use the device for a longer time.

Overview of the Components / Delivery Scope

1 Button for unlocking / locking the fi lter unit
2 LED charge indication

3 Multifunction button

/ + / –
4 Carrying handle
5 Socket for connection of the power supply unit
6 Dust collector base plate
7 Dust collector with HEPA fi lter
8 Lock of the dust collector
9 Opener of the dust collector

10 Suction tube

11 Unlocking the fl oor nozzle
12 Button for unlocking the brush roller

13 Floor nozzle with turbo brush

14 Unlocking for suction pipe or nozzle attachment
15 Adapter for the nozzle attachment
16 Combined crevice / brush nozzle
17 Upholstery brush
18 Wall holder
Not shown:
1 x Mains adapter
2 x Wall plug
2 x Screw

Unpacking the Device

1. Remove the device from its packaging.
2. Check the delivery scope for completeness.
3. Check the device for any transport damage, in order to
prevent hazards.
NOTE:
In case of any transport damage, contact your dealer
immediately. Do not use a damaged device!
4. Remove the transport lock from the multifunction button.
42
BS1307A_IM

Notes on Use

• The device is especially suitable for quickly vacuuming
small amounts of dry dirt or dust.
• The device is operated via charged battery. Charging is
done via the supplied power supply unit.
• Direct power supply via mains adapter is not possible.
Multifunction Button ( / + / –)
Use the multifunction button to turn the device on and off.
Also select a power level with this button.
Press once = Turn on the device, low power level
Press twice = Select high power level
Press three times = Turn off the device

Start-up

Suction Tube
• Insert the suction pipe with the two contact pins into the
connection on the hand unit. It must audibly engage.
• To disconnect the suction pipe, press the release (14) and
pull out the pipe at the same time.
Floor Nozzle with Turbo Brush
The fl oor nozzle is suitable for any fl oor covering. During
operation, the LEDs on the fl oor nozzle light up for better
visibility in dark areas.
CAUTION:
You cannot replace the LEDs.
• Slip the lower end of the suction pipe onto the connector
on the fl oor nozzle. Pay attention to the contact pin. The
suction pipe must audibly engage.
• To release the suction pipe, push the release (11) away
from the suction pipe and pull out the pipe at the same
time.
20.10.16