Cleaning; Floor Nozzle; Dust Container With Filter Unit; Storage - Clatronic BS 1307 A Mode D'emploi

WARNING:
• Always disconnect the appliance from the power supply unit before

cleaning!

• Under no circumstances should you immerse the motor housing
in water in order to clean it. Otherwise this might result in an elec-
tric shock or fire.
CAUTION:
• Do not use a wire brush or any abrasive items.
• Do not use any acidic or abrasive detergents.
• The single components are not dishwasher-safe.
• Wipe the casing with a damp cloth.
• You can wipe the mains adapter unit with a dry cloth.

Floor Nozzle

1. Disconnect the floor nozzle from the suction pipe.
2. Turn the floor nozzle around, so that you see the lower
side. Press the button (12) on the floor nozzle to unlock
the lock of the brush roller on the left side.
3. Pull out the brush roller.
4. Remove threads and hair wound to the brush. Use
scissors, if required.
5. Assembly:
Refer to the adjacent figure.
5.1 Set the brush
roller at position (1).
Make sure that the
triangular recess on
the brush roller is
positioned correctly.
5.2 Return the bearing of
the brush roller into
the housing of the
floor nozzle (position
2).
6. Close the lock of the brush roller. It must audibly engage.

Dust Container with Filter Unit

Please read the chapter "Maintenance" for cleaning of these
components.

Storage

• Clean the appliance as described and allow it to dry.
• You can use the previously installed wall holder for storage.
• We recommend that you keep the appliance in the origi-
nal packaging if it will not be used for long periods.
BS1307A_IM
Cleaning
NOTE concerning the life of the rechargeable
battery:
Even when switched off, the rechargeable battery dis-
charges continuously. When the device is out of use for
a longer period of time, charge the rechargeable battery
at least once every 6 to 12 weeks.
• Always store the appliance out of the reach of children in
a dry, well ventilated place.
Problem
The device
does not
function.
Weak suction
power.
Noise during
operation.
The floor
nozzle with
turbo brush is
not operating.

Troubleshooting

Possible cause Remedy
The rechargeable Charge the battery.
battery is empty.
The power supply Disconnect the
unit is connected. appliance from the
power supply unit.
The rechargeable Contact our service
battery is defect. or your dealer.
The battery is Charge the battery.
nearly discharged.
The dust container Empty the dust
is full. container.
The filters are Clean the filters as
dirty. described under
"Maintenance".
A foreign body has Remove the foreign
been sucked into body. If required,
the floor nozzle. disconnect the floor
nozzle from the
suction pipe
The brush roller is Clean the floor
blocked by dirt. nozzle as described
under "Cleaning".
Incorrect assembly Check the assembly.
of suction pipe
and / or floor
nozzle.
20.10.16
45