Important Safety Instructions For Battery Charger; Important Safety Instructions For Use Of The Battery And Battery Charger - Metabo DS 12DVF3 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

20. Definitions for symbols used on this tool.
V ............... volts
— --- .............. direct current
............. no load speed
n
o
---/min ...... revolutions per minute
IMPORTANT SAFETY INSTRUCTIONS FOR
BATTERY CHARGER
WARNING:
Death or serious bodily injury could result from
improper or unsafe use of battery chargers. To
avoid these risks, follow these basic safety
instructions:
READ ALL INSTRUCTIONS
1.
This manual contains important safety and
operating instructions for battery charger Model
UC18YG.
2.
Before using battery charger, read all instructions
and cautionary markings on (1) battery charger,
(2) battery, and (3) product using battery.
AC Input Rating Amperes*
Equal to or
greater than
0
2
3
*
If the input rating of a battery charger is given in
watts rather than in amperes, the corresponding
ampere rating is to be determined by dividing the
wattage rating by the voltage rating–for example:
1,250watts
125 volts
9. Do not operate battery charger with damaged cord
or plug-replace them immediately.
10. Do not operate battery charger if it has received a
sharp blow, been dropped, or otherwise damaged
in any way; take it to a qualified serviceman.
11. Do not disassemble battery charger; take it to a
qualified serviceman when service or repair is
required. Incorrect reassembly may result in a risk
of electric shock or fire.
RECOMMENDED MINIMUM AWG SIZE FOR
EXTENSION CORDS FOR BATTERY CHARGERS
but less
than
2
3
4
= 10 amperes
To reduce risk of injury, charge metabo HPT
3.
rechargeable battery types EB1214S, EB1414S,
EB1814SL and EB1820L. Other type of batteries
may burst causing personal injury and damage.
4.
Do not expose battery charger to rain or snow.
5.
Use of an attachment not recommended or sold
by the battery charger manufacturer may result in
a risk of fire, electric shock, or injury to persons.
6.
To reduce risk of damage to electric plug and cord,
pull by plug when disconnecting battery charger.
7.
Make sure cord is located so that it will not be
stepped on, tripped over, or otherwise subjected
to damage or stress.
8.
An extension cord should not be used unless
absolutely necessary. Use of improper extension
cord could result in a risk of fire and electric shock.
If extension cord must be used make sure:
a.
That blades of extension cord are the same
number, size, and shape as those of plug on
battery charger:
b.
That extension cord is properly wired and in
good electrical condition; and
c.
That wire size is large enough for AC ampere
rating of battery charger as specified in Table
1.
Table 1
AWG Size of Cord
Length of Cord, Feet (Meter)
25 (7.5)
50 (15)
18
18
18
18
18
18
12. To reduce risk of electric shock, unplug charger
from receptacle before attempting any
maintenance or cleaning. Removing the battery
will not reduce this risk.
IMPORTANT SAFETY INSTRUCTIONS FOR
USE OF THE BATTERY AND BATTERY
CHARGER
You must charge the battery before you can use the
cordless driver drill. Before using the model UC18YG
battery charger, be sure to read all instructions and
cautionary statements on it, the battery and in this
manual.
REMEMBER: USE ONLY metabo HPT BATTERY TYPES
EB1214S, EB1414S, EB1814SL, AND EB1820L. OTHER
TYPES OF BATTERIES MAY BURST AND CAUSE
INJURY!
English
100 (30)
150 (45)
18
16
16
14
16
14
7

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Ds 14dvf3Ds 18dvf3

Table des Matières