Getting Started; Insert Batteries; Remote Sensor; Sensor Data Transmission - Oregon Scientific Weather@Home BAR218HGX Mode D'emploi

Masquer les pouces Voir aussi pour Weather@Home BAR218HGX:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 31

GETTING STARTED

INSERT BATTERIES

1. Remove the battery compartment.
2. Insert the batteries, matching the polarities (+/-).
3. Press RESET after each battery change.
LOCATION
Clock / alarm area
Outdoor temperature
area

REMOTE SENSOR

The main unit can collect data from up to 5 sensors.
To set up the sensor:
1. Open the battery compartment.
2. Select a channel then press RESET.
3. Close the battery door.
4. Place the sensor within 98 ft (30 m) of the main unit
using the table stand or wall mount.
TIP Ideal placements for the sensor would be in any
location on the exterior of the home at a height of not
more than 5 ft (1.5 m) and which can shield it from direct
sunlight or wet conditions for an accurate reading.
BAR218HGX-UM-EN-R14.indd 4
MEANING
Main unit batteries low
Sensor batteries low
4
150cm(5ft)
NOTE Use alkaline batteries for longer usage and
consumer grade lithium batteries in temperatures
below freezing.

SENSOR DATA TRANSMISSION

To search for a sensor:
Press and hold
and MODE at a time.
The sensor reception icon in the remote sensor
area shows the status:
ICON
DESCRIPTION
Main unit is searching for sensor(s).
A channel has been found.
The sensor cannot be found.
2019/2/14 下午12:19

Publicité

Table des Matières
loading

Table des Matières