Battery Replacement & Care; Low Battery Indication - Beha-Amprobe VOLTfix Série Mode D'emploi

Safety
Compliance
EMC
Compliance
Certifications
BATTERY REPLACEMENT & CARE

Low Battery Indication

The NCV-1030/1040-EUR (MAGNO-)VOLTfix Voltage
Probe provide a low battery indication in the form
of a very slowly blinking red LED upon power on
when battery level is low and the batteries should
be replaced. At that point no voltage indication is
possible.
The NCV-1020-EUR VOLTfix does not provide the
same indication; instead, batteries will need to be
replaced when no LED appears upon power on.
Battery Replacement
To remove the battery cap, use the thumb grip to
pull it upwards and outwards. Remove batteries
and replace with (2) AAA 1.5 V alkaline batteries,
noting the battery orientation as shown on the
side of the Voltage Probe. Replace the cap.
If the Voltage Probe will not be used for a long
period of time, remove the batteries.
IEC 61010-1 3rd Ed., UL 61010-1 3rd
Ed., UL 61010-2-030, CAN/CSA-C22.2
No.61010-1-12, CAN/CSA-C22.2 No.
61010-2-030-12 to CAT IV 1000 V,
Pollution degree 2, IP65
IEC 61326-1
Korea (KCC): Class A Equipment
(Industrial Broadcasting &
Communication Equipment)
This product meets requirements
[1]
for industrial (Class A) electromagnetic
wave equipment and the seller or
user should take notice of it. This
equipment is intended for use in
business environments and is not to
be used in homes.

Latch
7
[1]
Battery Cap