Storch Opti-Air Mode D'emploi page 32

Do not draw off and emit hazardous solids, such as paint
mist, asbestos, sanding dust, etc. into the environment.
KEEP AWAY FROM MOVING PARTS.
DO NOT insert fingers or other objects into device
openings to prevent them from being severed by moving
parts or burnt on hot parts.
Using the STORCH Opti-Air ventilation and heating system
STORCH Opti-Air is a mobile intake and exhaust air ven-
tilation system with optional air heating.
STORCH Opti-Air is intended to ventilate enclosed env-
ironments. The device is used to prevent odour pollution
caused by solvents, reduce hazardous emissions in the
ambient air and boost the drying time of coating materi-
als, such as paint, adhesive, plaster as well as moist sub-
strates.
Maintenance
If necessary, clean the blower impellers to guarantee con-
sistent performance and prevent bearing damage. Simply
remove the blower impellers for cleaning. Make sure not
to change the balance weights within the blowers during
cleaning.
Prevent severe impacts which may cause bearing damage
on the motors.
Prior to starting work, make sure there are no foreign
parts in the blower housing. In the event of unusual
Translation of the original instruction
Disconnect the device from the mains prior to working on
it.
The installation only takes a few minutes and does not
require tools. Any other required accessories are included
in the scope of delivery. STORCH Opti-Air can be instal-
led on all standard windows.
STORCH Opti-Air combines high performance with low
noise development. This enables use of the device in
sensitive areas where no/low odour pollution by coating
materials or adhesives is a necessity.
noises, immediately switch off the blower and rectify the
cause.
Contact the STORCH Service Hotline or an authorised
Service Station.
Disconnect the device from the mains prior to working on
it.
32