Removing The Front Panel - Aiphone JP-DA Manuel D'installation

MOUNTING
JP-DA
Mounting screw × 2 (not included)
① Removing the
②
main unit from the
Main unit
mounting frame
Remove the main unit.
(Loosen the locking screws.)
Screwdriver
Tighten Loosen
JP-DV
Anchor × 4 (not included)
(Prepare anchors according to the
size of the mounting screws.)
Vandal-resistant front panel
Loosen
Special
screwdriver
Tighten
* Remove protective fi lm from camera before use.
JP-DVF
Vandal-resistant front panel
Hexagonal
wrench
Tighten
Special
×
screw 4
* Remove protective fi lm from camera before use.
Screw shaft: Ø4.1 or less
Slotted head: Ø8.2 or less, 3.0mm or less in height
Place " UP" upwards
Mounting frame
Drainage hole
Do not block the holes.
(The diameter and the depth of the
holes on the wall depend on the anchors
suitable for the mounting screws used.)
Mounting screw × 4 (not included)
Screw shaft: Ø4.1 or less
Slotted head: Ø8.2 or less, 3.0mm or less in height
Drainage hole
Do not block the holes.
Flush mount back box (included)
110 mm
(4-3/8'')
180 mm
(7-3/32'')
45 mm
(1-25/32'')
Transparent nameplate
③ Mount the main unit on the mounting frame, and fi t
the front panel on.
83.5 mm
(3-5/16")
Front panel Main unit
1-gang box
Inserting the transparent nameplates
① Remove the vandal-resistant front panel.
② Peel off the protective seals on the plate (both sides).
75 mm
③ Fill in the name of the resident on the transparent nameplate.
(3'')
Be sure to leave 25 mm (1") of white space on the right end to
account for insertion.
④ Insert the fi lled-in transparent nameplate at the specifi ed insertion
opening (indicated with
150 mm
(5-15/16'')
Using the transparent nameplates
Inserting the transparent nameplates
① Remove the vandal-resistant front panel from the fl ush mount back
box.
② Peel off the protective seals on the plate (both sides).
③ Fill in the name of the resident on the transparent nameplate.
Be sure to leave 25 mm (1") of white space on the right end to
account for insertion.
④ Insert the fi lled-in transparent nameplate at the specifi ed insertion
opening on the rear side of the vandal-resistant front panel (indicated
with in diagram).
ABC
4

Removing the front panel

<Bottom surface>
Pry off the front panel with
a fl athead screwdriver.
Using the transparent nameplates
in diagram) as below.
Insert
transparent
nameplate here.
25 mm
(1")
ABC
2 mm (1/8")
25 mm
(1")
2 mm (1/8")
Flathead
screwdriver