Maintenance And Cleaning; Emptying The Dust Container And Cleaning The Filter; Cleaning / Replacing The Side Brushes; Storage - Profi Care PC-BSR 3042 Mode D'emploi

WARNING:
• Always switch off the appliance before servicing or cleaning and
disconnect it from the power adapter!
• Under no circumstances should you immerse the appliance in
water for cleaning purposes. Otherwise this might result in an
electric shock or fire.
CAUTION:
• Do not use a wire brush or any abrasive items.
• Do not use any acidic or abrasive detergents.
NOTE:
Do not attempt to lubricate the rollers with lubricants or oil.
Ignoring this would cause significantly more dust or dirt to
adhere to the rollers.
• Clean the housing with a soft, dry cloth without additives.
• Use a soft cloth to gently clean the sensors (12/15/20).
CAUTION:
Prior to and after each use, check that the sensors are
clean. Otherwise, the appliance may tumble down a
staircase.
• Prior to and after each use, make sure that the nozzle
and vents are clear.
• For optimum performance of the appliance, you should
empty the dust container and clean the filters after each
use.

Emptying the Dust Container and Cleaning the Filter

CAUTION:
Never wash the filters under any circumstances.
Please refer to the images on page 4.
1. Press the corresponding surface to open the dust con-
tainer compartment.
2. Fold the handle upwards and remove the dust container
from the appliance.
3. Pull the HEPA filter out of the dust container. There is still
a rubber holder around the HEPA filter. Clean the HEPA
filter by tapping the dust out of it.
We recommend replacing the HEPA filter once a year.
CAUTION:
Do not use a brush to clean the HEPA filter. Using a
brush may damage the filter material.
4. Fold the cover of the dust container upwards. Then
remove the mesh filter from the dust container.
PC-BSR3042_IM

Maintenance and Cleaning

5. Empty the dust container while holding it over a garbage
can.
6. You can clean the dust container under running water.
To clean the mesh filter, use a soft paintbrush.
CAUTION:
• Allow the dust container to air dry. Do not, however,
expose it to direct sunlight.
• Only re-insert the filters into the dust container once
it is completely dry!
7. Reinsert the filters into the dust container. Make sure that
both the HEPA filter and the mesh filter are installed
properly.

Cleaning / Replacing the Side Brushes

If the side brushes are dirty, you may clean them with clean
water. Do not use any additional cleaning agents.
If the side brushes are worn or defective, replace them with
new ones.
1. The side brushes can be easily removed by pulling them
upwards.
2. When attaching the side brushes, pay attention to the
right (R) and left (L) markings. You will find these mark-
ings on both the appliance and on the side brush.

Storage

• Clean the appliance as described and allow it to dry.
• We recommend that you keep the appliance in the origi-
nal packaging if it will not be used for long periods.
• Always store the appliance out of the reach of children
in a dry, well ventilated place. The storage temperature
should be between 0 and 40 °C.
45
03.07.19