THOMSON ANT1410 Mode D'emploi page 5

5.2 Powering the antenna with the set-top box or
digital TV (fig. 2)
• Take the coaxial cable that attached on the antenna, and
connect it to the antenna input connector of your Set Top
Box (or Digital TV).
• Please make sure the antenna powering function of your
Set Top Box (or Digital TV) is activated.
• Turn on the power switch on the rear panel.
• Check the reception quality. If the reception quality is not
good, adjust the position or angle of the antenna.
5.3 Wall mounting (fig. 3)
Attach the Wall mounting unit to the back of ANT1410/
ANT1415. Please use the hook, screws and anchors to fix
the antenna on the wall.
Note
• Before mounting, check that the wall you have chosen
is suitable for the weight to be mounted Also make
sure that there are no electric, water, gas or other
lines running through the wall at the mounting site.
• After the product has been mounted, check that it
is sufficiently secure. You should repeat this check at
regular intervals.
5.4 Setting up the antenna on a table, cabinet or
similar (fig. 4)
Attach the provided stand to the rear of the antenna. Next,
place the antenna on an even surface such as a table or
entertainment stand. Check the reception quality. If the
reception quality is not good, adjust the position or angle
of the antenna.
6. Trouble shooting
If you cannot get the digital programs as you expect. Please
check the following conditions:
• Make sure the power switch on the rear panel is turned on.
• Check the connection. Make sure all the connection is
correct.
• Check the antenna powering (coaxial cable powering)
function of your STB. ANT1410/ ANT1415 is an active an-
tenna so you will need to enable the antenna powering
function. (Please check the operational manual of the STB
or TV.)
• If you place the ANT1410/ ANT1415 antenna on the TV
panel, please try to move the antenna away from the TV
panel. Some panel may reduce the signal reception of the
antenna.
• Adjust the direction and position of antenna to find the
best reception angle.
7. Care and Maintenance
Only clean this product with a slightly damp, lint-free cloth
and do not use aggressive cleaning agents.
8. Warranty Disclaimer
Hama GmbH & Co. KG assumes no liability and provides no
warranty for damage resulting from improper installation/
mounting, improper use of the product or from failure to
observe the operating instructions and/or safety notes.
9. Service and Support
Please contact Hama Product Consulting if you have any
questions about this product.
Hotline: +49 9091 502-115 (German/English)
Further support information can be found here:
www.hama.com
10. Recycling Information
Note on environmental protection:
After the implementation of the European Directive
2002/96/EU and 2006/66/EU in the national legal
system, the following applies: Electric and
electronic devices as well as batteries must not be
disposed of with household waste. Consumers are obliged
by law to return electrical and electronic devices as well as
batteries at the end of their service lives to the public
collecting points set up for this purpose or point of sale.
Details to this are defined by the national law of the
respective country. This symbol on the product, the
instruction manual or the package indicates that a product
is subject to these regulations. By recycling, reusing the
materials or other forms of utilising old devices/Batteries,
you are making an important contribution to protecting our
environment.
3