Hotpoint Ariston HB 0805 UP0 Mode D'emploi page 21

CHOPPER ATTACHMENT (only on some
models) (C)
The chopper is perfectly suitable for hard
food, such as chopping meat, cheese,
onion, herbs, garlic, carrots, walnuts, almonds,
prunes etc.
Don't chop extremely hard food, such as ice
cubes, nutmeg, coffee beans and grains.
1. Carefully remove the plastic cover from the
blade.
2. Fit the knife blade on the pin in the bowl - always
fit the knife blade before adding the ingredients.
3. Cut the food into small pieces and put them into
the bowl.
A small amount of water can facilitate the
smooth running of the appliance.
The mixture amount should not exceed the
max capacity of the bowl.
4. Close the lid.
5. Assemble the motor unit into the bowl lid until the
two small buttons on the left and on the right of
the connector have clicked.
6. Plug the appliance into the power outlet.
7. Rotate the speed-adjusting dial to select the
desired speed. Pressing and holding the ON/
OFF button, the attachment starts chopping
immediately. For maximum speed press the
TURBO button for a short time.
8. Remove the knife blade first before pouring out
the mixture.
Don't operate hard food for more than 10
seconds continuously.
FOOD PROCESSOR
(only on some models) (D-E)
To use the food processor attachment as a chopper
follow these instructions:
1. First of all make sure the non-slip ring is fixed to
the bottom of the bowl.
2. Fit the knife blade on the pin in the bowl - always
fit the knife blade before adding the ingredients.
3. Cut the food into small pieces and put them into
the bowl.
A small amount of water can facilitate the
smooth running of the appliance.
ATTACHMENT
The mixture amount should not exceed the
max capacity of the bowl.
4. Rotate counter clockwise the lid until blocked in
position, as shown in pic. 1
Make sure the food pusher is properly fitted
into its housing on the cover.
5. Assemble the motor unit into the bowl lid until the
two small buttons on the left and on the right of
the connector have clicked.
6. Plug the appliance into the power outlet.
7. Rotate the speed-adjusting dial to select the
desired speed. Pressing and holding the ON/
OFF button, the attachment starts chopping
immediately. For maximum speed press the
TURBO button for a short time.
8. Remove the knife blade first before pouring out
the mixture.
Don't operate hard food for more than 10
seconds continuously.
To use the food processor attachment with shredding/
slicing inserts follow these instructions:
1. First of all make sure the non-slip base is fixed to
the bottom of the bowl.
2. Fix the desired insert into the blades support as
shown in pic. 2
3. Put the support into the pin on the bottom of the
bowl.
4. Rotate counter clockwise the lid until blocked in
position, as shown in pic. 1
The fasteners must be locked in the two clip
positions, otherwise during operating the
bowl lid may rotate as the motor rotates.
5. Insert the bottom part of the motor unit into
the opening on the bowl lid, until the two small
buttons on the left and on the right of the
connector have clicked.
6. Plug the appliance into the power outlet.
7. Put the food inside the feeding tube and push it
slowly with the food pusher. Do not push heavily.
8. Rotate the speed-adjusting dial to select the
desired speed. Pressing and holding the ON/
OFF button, the attachment starts chopping
immediately. For maximum speed press the
TURBO button for a short time.
To remove the blades support after using
pull with two fingers as shown in pic. 3.
it en
21