dirna Bergstrom Bycool Integral Power Manuel De L'utilisateur page 10

INTEGRAL POWER
EN
Function F0 - Manual Operation
F0
By selecting the display shows the selected temperature and allows the user to choose
the comfort temperature that will appear on the display from 15ºC to 27ºC or 59ºF to 71ºF and
vary the speed of the centrifugal blower equipment (5 speeds indicated by
The comfort temperature is controlled by briefly pressing the
or on the remote.
Centrifugal blower speeds are controlled by holding down the
panel or from the command
V4 , V5 .
When the machine is running the selected degrees will appear on the display.
Function F1 - Digital thermometer function
In this function, Integral Power displays the interior cabin temperature.
Function F4 - Automatic operation of the equipment
F4
By selecting the user can select the comfort temperature 15ºC to 27ºC or 59ºF to 71ºF to be
selected from the
CA
When selected
this function the equipment automatically regulates and monitors the comfort temperature by
acting on the speed of the centrifugal blower and the compressors. By pressing the
on the remote control the
starting the machine for the first time it starts on F4 with the factory settings.
Function F6 - Selecting ºF
To activate this function, keep the On/off key
F6 , and then release the key to directly enable ºF. To return to ºC, keep the control panel
-
key pressed down with the unit switched off, at which point C will flash on the
display c
when it stops flashing, release the control panel key
is disabled when carrying out this operation, meaning it must be registered again once
finished.
on the remote control, the display will show
-
+
keys on the control panel or the remote control buttons
will appear interspersed on the display and the temperature selected. With
F4
function is cancelled and moves to
+
pressed down until the display shows
10
V1 V5
to ).
-
keys on the control panel
-
+
keys on the control
V1 , V2 , V3 ,
F0
(Manual Function). On
+ . The control
®
.
key