Grasslin Talento 971 Mode D'emploi page 51

10. Priority
Switching commands with the data assignment can be occupied with
different priorities (block number 00 and priority 0 is defined for
switching commands without date assignment).
If you start with a date during programming, a new block number and
priority 2 are always offered = default for a single date.
If a date range is entered – with the key
assigned. The priority can be changed between 1 and 9. The switching
command with the higher priority is executed first.
Example: Within a date range, e. g. 9.6 to 30.6 (priority 3),
it is possible to assign priority 4 or higher to a single day,
e. g. 22.6, but only in separate blocks.
09.06 bis 30.06
etc.
Blank line
Switching commands
Switching commands
...............
Pulse switching commands
Cycle switching commands
etc.
Block 01
Priority 3
22.06
etc.
Blank line
Switching commands
Switching commands
...............
Pulse switching commands
Cycle switching commands
etc.
Press the Prior. key step-wise.
The numbers change:
2 – 3 – 4 – ... – 9 – 1 – 2 – ...
etc.
1 – 2 – 3 – 4 – ... – 9 – 1 – 2 – ...
–, priority 1 is automatically
Block 02
Priority 4
24