Switching Commands - Grasslin Talento 971 Mode D'emploi

8.

Switching commands

The input of the switching commands applies to all types of assignment
• Switching commands without date assignment, always in block 00,
always with priority 0 (standard switching commands).
• Switching commands with single date, see Section 9.1
• Switching commands with date range, see Section 9.2
• Pulse switching commands, see Section 11
• Cycle switching commands, see Section 12
You determine the switching times and the switching state for the
relevat channel.
Symbol ON;
• Switching commands for each channel the same, all ON or all OFF
• Switching commands for each channel different, ON and OFF
Note: In the case of multi-channel clocks, channel 1 is always offered.
The switching state can also be deactivated for each channel.
No symbol = no switching.
OFF
Select free memory location:
Press the Prog. Key 1x.
– –.– –
– – – –
Setting the switching times:
Hours with the h key
Minutes with the m key
18