Front Molding Top; Front Molding Left; Front Molding Right; Mantel/Top - Twin-Star International 23MM070 Manuel D'instruction

Locate the three front molding pieces
10.
( EE,FF,GG) and four dowels.With the
three molding pieces face down on a
clean smooth flat surface.Insert dowels
into the two holes on the side molding
pieces (FF,GG). Carefully slide the left
(FF) and right (GG) side molding pieces
into place using the dowels. Locate flat
metal bracket (S) and place into spaces
in back of molding pieces.Attach bracket
to molding pieces using small wood
screws (T).
CAREFUL NOT TO OVER TIGHTEN.
11.
10
12. Insert one Wood Dowel (N) into each of
the pre-drilled holes on the top edges of
the Assembly from step 11. Then locate
Mantel/Top (I) and lay finished side up
on top of completed assembly. From the
inside, attach the Mantel using Bolts (L)
and Washers (M) through the pre-drilled
holes in the mounting blocks.
HAND TIGHTEN ONLY.
13.Using Phillips head screwdriver tighten
all Bolts alternating top and bottom, left
and right.
E-4
Front
Front Molding
Molding
Top
Right
N
GG
N
N
N
N
EE
Front
FF
Molding
Left
I
M
L
Completed Assembly
Molding
Bracket
S
T
Small
Wood
Screw
N
M
L
N
N