Publicité
INSTRUCTIONS FOR USE
Before using your appliance, read all the following instructions carefully, and pro-
ceed according to the instructions given:
IMPORTANT SAFEGUARDS
- Verify that the mains correspond to the voltage indicated on the bottom of the
appliance.
- Do never immerse the motor unit into water; wipe it with a damp cloth only.
- Do not operate the appliance with a damaged cord, plug or after the appliance
malfunctions, or has been damaged in any manner. Return the appliance to an
authorized dealer for examination and repair.
- Always unplug when not using, before assembly or dismantling the appliance.
- Never put your fingers into the lid-opening. Do always use the food pusher.
- This appliance is not intended for use by persons (including children) with re-
duced physical sensory or mental capabilities lack of experience and knowledge,
unless they have been given supervision or instruction concerning use of the ap-
pliance by a person responsible for their safety. Children should be supervised
to ensure that they do not play with the appliance.
- The use of accessories not recommended by the manufacturer may cause haz-
ards.
- Do not let the cord hang over edge of table or counter or touch hot surfaces.
- KB - 3 min. (maximum use with full power 3 min. before intermission).
- Save these instructions.
Assembly of adapter
1. Insert conveyor (L) into housing (C).
2. Put on knife (M) with cutting edges towards the outside.
3. Put selected perforated disk (N/K/J) over the knife.
4. Screw on the locking ring (O).
5. Put the now assembled mincer on the motor shaft of the motor unit, diagonally
from the right and turn it to the left until it clicks in (Dismantling: press button (D)
and turn out the mincer to the right).
6. Put on loading bowl (B).
7. The mincer is now ready for use: switch on the motor and fill in meat or vegeta-
bles. Press down lightly with the food feeder (A) while processing.
8. Should the conveyor (L) get blocked during use, press the reversal button (G).
Sausage spout
This accessory allows you to make your own sausages. Please proceed as follows:
1. Insert conveyor (L) into housing (C)
2. Put spacer (P) on conveyor (L).
6
ENGLISH
Publicité
