Special Functions - Siemens KA D Série Notice De Montage Et D'utilisation

Special functions

[timer]
You can use this function to set a period of time of 0-
99 minutes. A signal reminds you, e.g. when food is
to be taken out of the compartment after a certain time.
A value of 20 minutes has been preset at the factory.
m
Caution
Drinks bottles may crack if they are stored for longer
than 20 minutes in the freezer compartment.
Switching on the [timer]
1. Keep pressing the "options" button, until the [timer]
function is marked with an arrow.
2. Activate by pressing the setting button + (function is
framed).
3. Press the setting buttons +/- to set the required time.
Note
Repeatedly press the button to change the time
in one minute intervals. If the button is held down,
the time changes in 3 minute intervals.
4. Press the "options" button to start the time cycle.
Switching off [timer]
To deactivate the function, simultaenously press
the setting buttons + and - for 3 seconds.
[eco]
This function switches the appliance to energy-saving
mode.
The appliance automatically sets the following
temperatures:
Freezer compartment: : -16 °C
■
Refrigerator compartment: +6 °C
■
Switching on the [eco]
1. Keep pressing the "options" button, until the [eco]
function is marked with an arrow.
2. Activate by pressing the setting button + (function is
framed).
Switching off the [eco]
1. Keep pressing the "options" button, until the [eco]
function is marked with an arrow.
2. Deactivate by pressing the setting button - (function
is no longer framed).
[vacation]
If leaving the appliance for a long period of time, you
can switch the appliance over to the energy-saving
vacation mode. The refrigerator compartment
temperature is automatically switched to +14 °C.
m
Caution
Do not store any food in the refrigerator compartment
during this time!
Switching on the [vacation]
1. Keep pressing the "options" button, until
the [vacation] function is marked with an arrow.
2. Activate by pressing the setting button + (function is
framed).
Switching off the [vacation]
1. Keep pressing the "options" button, until
the [vacation] function is marked with an arrow.
2. Deactivate by pressing the setting button - (function
is no longer framed).
[clock]
The time is indicated on the time display panel. You
can set the time with the [clock] function.
Setting the time
1. Keep pressing the "options" button, until the [clock]
function is marked with an arrow.
2. Activate by pressing the setting button + (function is
framed).
3. Press the setting buttons +/- to set the required time.
4. Save the set time with the "options" button.
Note
If the [timer] function is switched on, the time is not
displayed.
en
45