Bestron DNHD42 Mode D'emploi page 40

Pay attention to the following coding:
Wire colour
Brown or black
Blue
2x yellow/green
(motor housing and distance sleeve)
5. Remove the fan from the hook of the attachment plate.
6. Attach the motor housing to the attachment plate by placing the two grooves in the protective cover over
the bolts in the attachment plate. Slightly rotate the protective cover anticlockwise.
Make sure the rotating fans cannot touch you or other objects.
7. Tighten the two bolts.
8. Insert the two loose bolts through the grooves in the side of the attachment cover and screw them firmly
into the attachment plate.
AsseMBly - installing the light fitting and the halogen lights
Take the following parts from the packaging:
• Light fitting
• Three halogen lights
The light fitting is attached to the underside of the
ceiling fan.
1. Remove the circlip from the halogen spotlights.
2. Place the halogen light bulbs into the light
fitting and screw them in clockwise.
3. Place the circlip back on the halogen spotlights.
4. Remove the plug from the motor housing's socket.
5. Unscrew the three bolts from the side of the
light fitting.
6. Fit the light fitting in place.
• Insert the light fitting's plug into the motor
housing's socket.
• Insert the light fitting into the bottom of the
motor housing and secure it in place by
tightening the three bolts.
AsseMBly - Balancing the fan
Take the following parts from the packaging:
• Balancing clip
• Two balancing weights
During manufacture, we ensure that your ceiling fan is of the highest possible quality. However, the fan may
sometimes not be balanced correctly. This is usually due to irregularities in the fan blades or the attachment
brackets. If the fan is not balanced, check the following:
• The attachment plate must be fitted as close as possible against the ceiling.
• If the distance sleeve is used, then this must be securely fixed. If you change anything to the distance
sleeve, make sure you also re-tighten the screw.
• The fan blades must be firmly attached to the assembly brackets.
• The assembly brackets must be firmly attached to the motor housing.
• The fan blades must be evenly distributed when viewed from below. If necessary, carefully reposition
them.
• The ends of the fan blades must all be the same distance from the ceiling. Measure this by placing
ruler against the ceiling and measuring the distance from the ceiling to the end of a fan blade. Do
this for all four fan blades. If one of the fan blades is not the same distance from the ceiling as the
others, correct it by carefully bending the blade.
connect to
L
N
Earth Not always present, but
recommended!
40
instruction manual