Bestron DNHD42 Mode D'emploi page 39

instruction manual
6. Tighten the three bolts.
7. Repeat this for the other three fan blades.
8. Take a long M5 bolt and place a spring washer
over the screw thread.
9. Place a paper gasket over the screw thread and
screw the bolt firmly onto the motor housing.
10. Repeat this for the other two bolts.
11. Screw the remaining three fan blades into
place.
AsseMBly - connecting the wires of the motor housing
1. Connect the wires in the motor housing to the
connector in the attachment plate.Pay attention
to the following coding:
Wire colour connect to
Brown L
Blue N
Black L
2. Attach the eye of the green/yellow earth wire to
the attachment plate.
AsseMBly - connecting the wires of the motor housing
Take the following parts from the packaging:
• Two screws with washers
1. Unscrew two bolts on opposite sides of the
attachment plate.
If a distance sleeve is used, make sure the cam
in the protective cover falls into the groove at
the top of the distance sleeve.
2. Secure the attachment plate to the ceiling using
two attachment screws with washers.
3. Hang the fan from the hook of the attachment
plate. This will make it easier to connect the fan.
4. Connect the wires hanging down from the
ceiling to the connector in the attachment plate.
5. Attach the eye of the green/yellow earth wire in
the motor housing to the protective cover.
6. Attach the eye of the green/yellow earth wire of
the distance sleeve
cover.
7. Attach the eye of the green/yellow earth wire of
the protective cover to the attachment plate.
to the protective
39