Disc Handling - Hitachi AXM649BT Notice D'utilisation

Bluetooth microsysteem
Masquer les pouces Voir aussi pour AXM649BT:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 29

Disc Handling

Handling Precautions
Hold the disc by the edges so the surface will not be soiled with fingerprints. (A)
Fingerprints, dirt and scratches can cause skipping and distortion.
Do not write on the label side with a ball-point pen or other writing implements.
Do not use record cleaning sprays, benzine, thinner, static electricity prevention liquids or any
other solvent.
Be careful not to drop or bend the disc.
Do not install more than 1 disc on the disc tray.
Do not try to close the disc tray when the disc is not installed properly.
Be sure to store the disc in its exclusive case when not in use.
If the surface is soiled (B)
Wipe gently with a soft, damp (water only) cloth.
When wiping discs, always move the cloth from the center hole toward the outer edge.
(If you wipe the discs using a circular motion, circular scratches are likely to occur, which will
cause noise.)
If the disc is brought from a cold to a warm environment, moisture may form on the disc. Wipe
the moisture off with a soft, dry, lint-free cloth before using the disc.
Improper disc storage
You can damage discs if you store them in the following places:
Areas exposed to direct sunlight.
Humid or dusty areas.
Areas directly exposed to a heat outlet or heating appliance.
The disc formats can play in this unit:
Audio CD, CD-R, MP3 and WMA disc.
01_AXM649BT_GB_P41013409-A101_20 Mar 13.indd 23
GB-23
2013-3-20 9:44:23

Publicité

Table des Matières
loading

Table des Matières