Set The Alarm Timer; Activate / Deactivate Alarm Timer; Set Sleep Timer - Hitachi AXM649BT Notice D'utilisation

Set the alarm timer

This unit can be used as an alarm clock. You can select DISC, USB or TUNER as alarm source.
Note:
■ Ensure that you have set the clock correctly.
1. In standby mode, press and hold the
display.
2. Press /
G / VOL +/–
H
3. Press button to confirm. The hour digits are displayed and begin to blink.
TIMER
4. Press /
G / VOL +/–
H
then press
TIMER
The minute digits are displayed and begin to blink.
5. Press /
G / VOL +/–
H
then press
TIMER
6. Press to adjust volume, and then press
VOL +/-
A clock icon appears on the display.

Activate / deactivate alarm timer

1. In the standby mode, press
* If timer is activated, the
* If timer is deactivated, the
Note:
■ The alarm timer is not available when the source is set as "AUX".
■ If the USB source is selected but no device connected, the unit switches to TUNER automatically.

Set sleep timer

This unit can switch to standby mode automatically after a set period.
1. When the unit is turned on, press
When the sleep timer is activated, SLEEP icon "
* To deactivate the sleep timer, press
01_AXM649BT_GB_P41013409-A101_20 Mar 13.indd 22
TIMER
button on the remote control or on the front panel to select source.
button on the remote control or on the front panel to set hour, and
button again.
button on the remote control or on the front panel to set minute, and
button to confirm.
button repeatedly.
TIMER
icon is displayed.
icon disappears on the display.
button repeatedly to select a preset period (in minutes).
SLEEP
OFF
120 90
SLEEP
button until [TIMER SET] (set timer) scrolls on the
button to confirm.
TIMER
...
45 30
" displayed.
button repeatedly until [OFF] (sleep off) appears.
GB-22
15
2013-3-20 9:44:23