Important Information; First Use And Operation - Unold 8210 Notice D'utilisation

IMPORTANT INFORMATION

Due to it's power rating and protective class the kettle model 8210/8216
cannot be operated with an Euro plug (dipole). Please check before your
travel which type of power sockets are used in the respective country
and check if your travel adapter has the correct socket for the kettle.
Please check also the available voltage in the travel country. When used in a
110 V~ net as e.g. in the United States, the kettle achieves only a quarter of the
rated power, i.e. approx. 250 W.

FIRST USE AND OPERATION

1. Before the first use just wipe the kettle inside and outside with a damp
cloth.
2. Open the lid by counterclockwise turning and fill the container with water.
3. Fill in at least 0.2 l, but not more than 0.5 l max. acc. marking on the scale.
4. Close the lid acc. to the marks by turning it clockwise until it clicks into
place.
5. Put the signal pipe on the opening.
6. Plug the power cord into the mains and press the on/off-switch. The control
light below the water scale will turn on.
7. Bring the water to boil. The pipe whistles as soon as water is boiling. Switch
off the appliance and pull the plug out of the socket to switch off the kettle.
8. Take off the signal pipe. Take care of hot steam. It is not necessary to open
the lid to pour out water.
9. The water from the first boiling cycle should be poured away, as it may con-
tain minor dust residues.
Boiling water can cause scalding. Therefore, please handle the appliance
with care when it contains hot water.
The appliance becomes very hot during operation and maintains the heat
during some time after disconnection.
Warning: The appliance does not switch off alone!
Stand 18.2.2020
Copyright UNOLD AG | www.unold.de
DE
EN
FR
NL
IT
ES
PL
15 von 44