HQ DIGICHAR120 Mode D'emploi page 3

-
For batteries with charging connectors on the flat panel:
Adjust the spring contactors pointing up (vertically) by pressing both
sides of the "angle stop releasing knob" (4). Make contact with the
battery charging connectors until the yellow LED (5) indicator turns
on; then affix the battery with cover (7) (please refer to Fig. 2.2).
2.3 Connect the AC adapter with the charger to the AC power outlet,
then affix the battery position and the charging will start. The LED
indicator (8) will light up.
2.4 The charger will automatically detect the battery polarities and voltage
and start charging once the connections are correct and secured.
3. Charging Indication
3.1 When lithium-ion battery polarities are detected and secured, the
yellow LED (5) will be light up; press (7) cover holder to affix the
battery.
3.2 When the charger is powered (6), the green LED (8) will light up.
The charger is ready to use. When the yellow (5) & red LEDs (8)
light up, the installed battery is charging.
Fig. 2.1
Fig. 2.2
3