HQ DIGICHAR120 Mode D'emploi page 2

1. Parts Names
1. Charging contactors rail shifters
2. Angle adjustable charging contactors module
3. Battery holder releasing knob
4. Angle stop releasing knob
5. Battery connected indicator
6. Power input socket
7. Battery holder
8. Battery charging indicator
9. USB output port
10. Battery tray
2. Lithium-Ion Battery Charging Mode
DO NOT connect the charger to the AC power source before (Lithium)
battery polarities are detected and the yellow LED (5) lights up.
2.1 Remove the Lithium battery from its device and place it in the tray
(10) of the charger.
2.2 Check the polarity by adjusting the spring contactors with battery
charging connectors until the yellow LED (5) indicator turns on.
-
For Batteries with charging connectors on the side panel:
Adjust the spring contactors pointing horizontally by pressing both
sides of the "angle stop releasing knob" (4). Make contact with the
battery charging connectors until the yellow LED (5) indicator turns
on; then affix the battery with the cover (8) (please refer to Fig. 2.1).
ENGLISH
2