Adjusting The Angle - Perel TC78074N Mode D'emploi

6. Operation
 The appliance must be placed on a steady surface.
 Before connecting the appliance to the power supply please check if the appliance is switched off.
 Put the power supply cable into the socket.
6.1 The Thermostat
 The appliance starts working when one of the above positions is used.
 The appliance does have a thermostat. When the temperature has reached the preferred temperature the
heating element will stop automatically. When the temperature is going down the heating element will be
switched on again.
WARNING: After the heating element is switched off automatically, the fan will still blowing till the appliance
has cooled down. This means it will blow away the hot air and you will get a possible cold feeling in your room.
To prevent this cold feeling you could turn off the appliance.
 When the appliance is switched off (with supply cord in socket) the fan will keep blowing till the appliance is
cooled down.
 Pull out the supply cord when you do not use the appliance.
6.2

Adjusting the Angle

 Slightly loosen the adjustment knobs while holding the body with one hand.
 Tilt the body to the desired angle and retighten the adjustment knobs.
V. 04 – 04/09/2017
TC78074N
www.provence-outillage.fr
4
04 90 78 09 61
©Velleman nv