Names And Functions Of Indicators On Remote Controller; Display Panel - Zibro S1825 Manuel D'utilisation

auto-timed setting in 30 minutes increments. When the setting time displays 10Hr, each press will incre-
ase the auto-timed setting 60 minutes increments. To cancel the auto-timed program, continue pressing
the button until nothing displays.
Timer off Button: Press this button to initiate the auto-off time sequence. Each press will increase the
auto-timed setting in 30 minutes increments. When the setting time displays 10Hr, each press will incre-
ase the auto-timed setting 60 minutes increments. To cancel the auto-timed program, continue pressing
the button until nothing displays.
RESET Button: When you press the recessed RESET button, all current settings are cancelled and the
control will return to the initial settings.
CLEAN AIR Button: This button is used to activate the function of Plasma Dust Collector. Push it again
to stop the function.
LOCK Button: When you press the recessed LOCK button, all current settings are locked in and the
remote controller does not accept any operation except that of the LOCK. Press again to cancel the
LOCK mode.
TURBO Button: Push this button on COOL mode, the air conditioner goes into powerful cooling ope-
ration. Push again to cancel the TURBO function.
LED DISPLAY Button: Press this button to clear the digit display in the air conditioner, press it again
to activate it (Not applicable to units without this function).

Names and Functions of indicators on Remote Controller

Display Panel

DIGITAL DISPLAY area:
This area will show the set temperature and, if in the TIMER mode, will show the ON and OFF settings
of the TIMER. If in the FAN mode, nothing is appeared.
TRANSMISSION Indicator:
This indicator lights when remote controller transmits signals to the indoor unit.
ON/OFF Indicator:
This symbol appears when the unit is turned on by the remote controller, and disappear when the unit
is turned off.
OPERATION MODE Indicator:
When press the MODE button, it shows the current operating mode -- AUTO COOL DRY HEAT (Cooling
only model without) mode.
LOCK Indicator:
LOCK display is displayed by pushing the LOCK button. Push the LOCK button to clear display.
TIMER DISPLAY Indicator:
This display area shows the settings of the TIMER. That is, if only the starting time of operation is set,
it will display the TIMER ON. If only the turning off time of operation is set, it will display the TIMER
fig. 2
4
109