Hansgrohe AXOR Bouroullec 19704001 Mode D'emploi page 8

3

4
1
5
8
English
Installation
Cut the plaster shield so that it extends ¹⁄₁₆" - ⅛" from
the finished wall surface.
1
1
Remove the flush insert screw using a 5 mm Allen
wrench ().
Remove the flush insert and seals.

5 mm
Insert the function block.
Install and tighten the function block screws using a 4
mm Allen wrench.
4 mm
Close the stops using a 4 mm Allen
wrench.
Seal the wall around the plaster
shield with waterproof sealant (1).
Failure to seal the wall can lead to
possible water damage.