Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

If charging does not start automatically, press the ON/OFF
button
NOTE
If the device to be charged has a Micro-USB, you can
also use the Power Bank's Micro-USB charging cable
During the charging process, the current charge level of the
Power Bank is shown via the charge level LEDs
To stop charging, disconnect the charging cable from the
mobile device and the Power Bank. The charging status LEDs
go off after about 20 seconds.

Troubleshooting

The Power Bank does not charge
Connection may be faulty. Check the connection.
A connected device will not charge
The integrated battery is empty. Charge the battery.
No connection to the device. Check the connection.
Press the ON/OFF button
The charging process stops after about 20 seconds
The charging current of the connected device is less than
45 mA. This device cannot be charged with the Power Bank.
The Power Bank does not react when several devices
are connected even though the battery is charged
The power consumption of the connected devices is too high.
This has triggered the internal overcurrent protection. Reduce
the number of connected devices and press the ON/OFF
button
will need to connect it to the charger for 2 seconds.
NOTE
If you cannot solve the problem with the above-men-
tioned solutions, please contact the Service Hotline (see
chapter entitled Service).
GB │ IE │ NI
8 
briefly to start the charging process.
. If the Power Bank still cannot be switched on, you
to start the charging process.
.
.
SPB 6000 A1

Publicité

Table des Matières
loading

Table des Matières