SQuape N dupo Manuel D'utilisation page 15

5.3 Refi lling the SQuape N[duro]
Before you can refill the tank, make sure that
the device is in „closed" mode. The O symbol
should be above the mark on the edge of the
base. In this tank position, you can turn the
top cap counterclockwise or clockwise until
both filling holes are completely open. Fill the
tank with a suitable bottle. Then turn the top
cap back so that the filling holes are covered.
Make sure that the red o-rings of the filling
holes are no longer visible. The tank is now
closed again. Now you can set the tank to
the desired position („vape", „remove") by
turning it clockwise.
Fig. 2
5.4 Replacing the glass tube
Remove the tank from the base and emp-
ty it completely. Pull the top cap off at the
top using the supplied SQ Grip Band. Wash
the tank briefly under running water. A hex
key (size 5) can be inserted into the chim-
ney from below. Unfasten the chimney from
the tank and remove it completely. Now the
glass can be removed from the tank. When
assembling, please make sure that the
o-rings are undamaged and in the intended
position. After inserting the o-rings and the
glass, turn the chimney back into the tank
using the hex key. Finally, press the top cap
over the provided o-ring at the top of the
chimney.
Fig. 3 Fig. 4
15