Bosch HDD80050UC Instructions D'installation page 19

be done by qualiied person(s) in accordance with all
applicable codes and standards, including ire-rated
Do not use an extension cord. If the
product power cord is too short, have a qualiied
1. Install a standard wiring box, with 3-pronged receptacle,
2. Remove electrical panel wiring box cover. Secure
blower power cable to electrical panel wiring box with
GREEN
WHITE
BLUE (cap off)
M RED
ORANGE
BLACK
FLEXIBLE
BLOWER
3. Connect lexible blower wires to wires in electrical panel
wiring box as shown. Cap off BLUE wires (LOW 1).
4. Replace wiring box cover.
ELECTRICAL PANEL
GROUND SCREW
WHITE (NEUTRAL)
RED (MED 2)
ORANGE (MED-HIGH 3)
BROWN (HIGH 4)
WIRING
BOX
3. The following exterior or inline blowers can be used:
DHG6023RUC - 600 cfm (17 m /min) Remote Blower
DHG6015NUC - 600 cfm (17 m /min) Inline Blower
120 VAC • 60 Hz • 5.0 A (max.)
M
REMOTE
14/4 ROMEX
BLOWER
OR CONDUIT
wiring should be connected in an approved junction box.
box as shown.
6. Replace wiring box cover.
3. Remove all protective ilm and packaging before operation.
In order to remove all protective ilm and packaging, raise
the ilter area.
ELECTRICAL PANEL
GROUND SCREW
WHITE (NEUTRAL)
RED (MED 2)
ORANGE (MED-HIGH 3)
BROWN (HIGH 4)
WIRING
BOX