Bosch HDD80050UC Instructions D'installation page 14

1/2" (13mm) clearance
1. Place the downdraft on its back on a table or lat work
SUPPORT
LEGS
Attach long or short support legs (depending upon
cabinet height) to bottom sides of unit with hex screws
provided. Do not tighten hex screws completely at this
Downdraft cutout width:
30" (762) is 27-1/16" (687)
36" (914) is 33-1/16" (840)
BT
MIN.
1/2"
(13)
CHANNEL
UPPER
SUPPORT
BRACKET
HEX SCREW
1/4-20 X .500 (12.7MM)
Template
2-1/8" (54)
1-7/8" (48)
Example: There is a drawer
SLIDE
1. Remove (2) #8-32 hex nuts and
unplugged (as shown)
24-11/16" (628)
22-5/16" (567)
19-1/8" (486)
1-1/16"
(27)
Cooktop cutout width
Measurements in inches (mm).
#8-32 HEX
NUTS
INTERCONNECT CABLE (5-FT. (1.5 M) LONG)