Assembly - Rohde HMT 600 Manuel D'utilisation Original

12.3.2.

Assembly

Step Description
Preparing the pottery wheel:
The worktop as well as the location
1
bolts and the storage inside the
plastic protection tube must be clean
and dry.
Fit the clean splash pan.
Attention:
2  The drain hose must be
positioned centrally over the hole
in the worktop.
 The hose must not be kinked.
Put on the wheel head.
Attention:
 Make sure that the wheel head
3 can be placed on the locating
bolt without any effort or tilting.
 Make sure that the carriers on
the machine fit exactly into the
recesses in the wheel head.
Insert and tighten the screw in the
centre.
4
Tool:
8 mm Allen key
(included in the pottery wheel's scope
of delivery)
Torque:
10 Nm
Illustration
54 / 207 - EN -