Makita DTR180 Manuel D'instruction page 2

ENGLISH (Original instructions)
SPECIFICATIONS
Model:
Tie wire (Optional accessory)
Diameter of rebars that can be tied
Approximate number of ties per reel
Overall length
Rated voltage
Net weight
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications and battery cartridge may differ from country to country.
• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi-
est combination, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge
Charger
• Some of the battery cartridges and chargers listed above may not be available depending on your region of
residence.
WARNING:
Only use the battery cartridges and chargers listed above. Use of any other battery cartridges
and chargers may cause injury and/or fire.
Combination of rebars that can be tied
Combination of 2 rebars
#3 (10 mm)
#4 (13 mm)
#5 (16 mm)
Combination of 3 rebars
#3 (10 mm)
#4 (13 mm)
#5 (16 mm)
Combination of 4 rebars
#3 x #3 (10 mm x 10 mm)
#4 x #4 (13 mm x 13 mm)
NOTICE:
If there is a gap between rebars or if the tool is used at an incorrect orientation, the rebars may not be
able to be tied.
D.C.14.4 V Model
D.C.18 V Model BL1815N / BL1820B / BL1830 / BL1830B / BL1840B / BL1850B / BL1860B
2 ENGLISH
DTR180
ø0.8 mm (21GA)
From #3 x #3 to (#4 x 2) x (#4 x 2)
From 10 mm x 10 mm to (13 mm x 2) x (13 mm x 2)
Approximately 120 ties
304 mm (12")
D.C. 14.4/18 V
2.3 - 2.6 kg (5.1 - 5.7 lbs)
BL1430B
DC18RC / DC18RD / DC18RE / DC18SD / DC18SE / DC18SF
#3 (10 mm) #4 (13 mm)
#3 x #3 (10 mm x 10 mm)
#3 x #3 (10 mm x 10 mm)
#5 (16 mm)
#4 x #4 (13 mm x 13 mm)
-
#4 x #4 (13 mm x 13 mm)