Heating Settings (See "Other Functions For The Installer" Section, P 76); Wifi Settings (See "Wifi Settings" Section, P 77); General Factory Default (See "Other Functions For The Installer" Section, P 76); Update Firmware (See "Other Functions For The Installer" Section, P 76) - LVI TOUCH E3 Manuel D'installation Et D'utilisation

> Select "Yes"if the radiator's front and back panel should be heated sequentially.
> Press "Green check"button to confirm.
08. Screen lock
• Press "Screen lock" button
• Enter your personalized code (it must contain 4 characters)
• Press "Green check" button to confirm
Note: the default code is 1066
09. Heating settings
Set Minimum and Maximum allowed temperatures in each room. You can also
calibrate the measured temperature by adding an offset
• Press "Heating Settings" button
• Press a room button
10. H&C Heating and Cooling. Should be "Heating Only" when only electric radiators are
used. For Cooling, see separate manual.
11. WiFi settings (See "WiFi settings" section, p 19)
12. General factory default (all updates and user data will be erased except WiFi-
settings. They are reset under WiFi settings (See "WiFi settings" section, p 19)
by pressing the the Red "Reset" button (long press)
• Press "Green check"button to confirm
• Press "Red cross"to decline
13. Update firmware
• Make sure your Touch E3 is securely connected to power. A power cut during upgrade
might damage your device permanent!
• Insert the SD card (the system is qualified to work with FAT formatted SD-cards less
than or equal to 8 GB) with new firmware only.
• Press "Update firmware"
• Press "Green check" button to confirm (or Press "Red cross"to decline)
• The upgrade could take some time, up to 5 minutes. Depending on firmware release
you had before, you will see on or several upgrade cycles, where Touch E3 is rebooting
and upgrading automatically.
• Go to the "Main menu" and wait for you Wifi Icon turns blue (active).
• Turn OFF your Touch E3, wait 30 seconds and turn it ON again.
• Go again to the "Main menu" and wait for you Wifi Icon turns blue (active) again.
• Eject the SD card from your Touch E3 after upgrade.
14. Cloning
Allows you to transfer the configuration (language and wifi settings will not be copied)
from one unit to another. Download a special "update.bin" for cloning (not the same as
for firmware update) on a SD card, insert it in the first unit
and make an "update firmware", the insert it in the other unit and press "Cloning"
15. Parameters
Development tool for manufacturer
FOR THE INSTALLER AND FOR
UK
ADVANCED USERS
P16MI417 - A06- 03/18
19 |