Free Room; Installation - Zanotti AS Rotary Série Notice De Mode D'emploi Et D'entretien

6.4 Free room

When installing the unit leave enough free room to allow opening, correct use and easy maintenance in safe
conditions.

6.5 Installation

Prepare an opening with suitable dimensions in the cold room wall (see picture).
A
Condensate drain
line D (I)
AS121
AS221
AS135
AS235
AS335
AS340
A) Position the unit on the cold room inserting the evaporator section in the opening.
B) Fix the unit using the screws supplied.
C) Fit a drain line to the defrost water drain connection in the lower part of the condensing
unit.
N.B.: Before siting the unit (only for the models AS121 and AS123), dismount the front panel
-Iniettare silicone su tutto il perimetro del tampone.
Sul lato superiore eseguire l'operazione prima del posizionamento.
-Inject silicone all around the panel opening.
Apply silicone on the upper side before positioning the unit.
-Injecter de la silicone sur tout le périmètre du tampon.
Sur la partie supérieure injecter avant de fixer l'Uniblock.
-Silikon auf den ganzen Öffnungsumfang einspritzen.
Bevor der Uniblock eingebaut wird, dieses Verfahren auf der Oberseite ausführen.
-Inyectar silicona sobre todo el perimetro del agujero.
Sobre la parte superior se coloca antes de situar el Uniblock.
A B C
705 300 305
695 300 305
800 470 400
857 470 440
857 500 440
857 570 490
Inject silicone seal all around
the panel opening
D E F
100 420 305
100 420 305
120 580 475
120 580 480
120 850 510
120 970 580
-Foro
-Hole
-Trou
-Loch
-Agujero
425
Hole
G H
425 100
725 100
725 100
1130 100
1600 100
1640 100
A.
I
10
10
10
18
22
22
21