W O L F
G R I L L M O D U L E
I N S TA L L AT I O N
R E Q U I R E M E N T S
IMPORTANT NOTE: Save these Installation
Instructions for the local inspector's use.
Please read the entire Installation
Instructions prior to installation.
This installation must be completed by a
qualified technician.
Installer: please retain these instructions
for local inspector's reference, then leave
them with the homeowner.
Homeowner: please read and keep
these instructions for future reference and
be sure to read the entire Use & Care
Information prior to use.
IMPORTANT NOTE: This appliance must be
installed in accordance with local codes. The
correct voltage, frequency and amperage
must be supplied to the appliance from a
dedicated, grounded circuit which is protected
by a properly sized circuit breaker or time
delay fuse. The proper voltage, frequency, and
amperage ratings are listed on the product
rating plate.
Record the model and serial numbers before
installing the grill module. Both numbers are
listed on the product rating plate located on
the underside of the module. Refer to the
illustration below.
Location of rating
plate under module
Rating plate location
B E F O R E
Y O U S TA R T
IMPORTANT NOTE: Installation and
service must be performed by a qualified
installer or service agency.
Installation of the grill module must meet
the minimum clearance requirements for
safe operation. Refer to Site Preparation
on page 6.
If the grill module is to be used with any
combination of additional cooktop units or
modules, refer to Multiple Cooktop Installa-
tion on page 8.
Electrical installation must be adequate
and in compliance with all local codes and
ordinances. Electrical ground is required,
refer to Electrical Requirements on page 9.
IMPORTANT NOTE: A ventilation hood is
recommended (but not required) for use with
the Wolf electric grill module.
This module is intended for indoor use.
Model ICBIG15/S
Model Number
ICBIG15/S
Serial Number
5