Wolf ICBIG15/S Instructions D'installation page 10

I N S TA L L AT I O N
M O D U L E
To prevent pollution from entering the controls
area, attach the foam strip to the underside of
the module frame. Refer to the illustration
below.
Gently lower the grill module into the cut-out
area in the countertop and center. Check that
the front edge of module is parallel to the front
edge of the countertop. Check that all required
clearances are met.
To attach the brackets to the sides of the
module, insert the clip into the rectangular
punchout in the pan, and push down. Install
the clamping screw into the bracket and
tighten until the screw contacts the underside
of the countertop. Do not overtighten screws.
Refer to the illustration below.
IMPORTANT NOTE: Do not use caulk or
silicone to seal the module to the countertop.
The unit must be readily removable for service.
Foam strip
10
I N S T R U C T I O N S
I N S TA L L AT I O N B E F O R E O P E R AT I N G
Read the entire Wolf Grill Module Use & Care
Information included with the module. Impor-
tant safety, service and warranty information is
contained within the book.
Thoroughly clean the grilling grate, grease
deflection plates and grease collection pan
with mild soap and water before use.
Installation brackets