Weidmüller WAVESERIES Thermo Select WTS4 Notice D'utilisation page 20

3.3 Pluggable cross-connections for voltage supply
(Page 75, Fig. 3)
A maximum feed through of 2 A is possible.
If a signal conditioner is accidently rotated through 180°, the
cross-connection cannot be inserted.
3.4 Labelling possibilities
(Page 75, Fig. 4)
WS 10 connector markers can be used to label module.
4 Calibration
Warning!! The power supply must be disconnected, before
changing the signal conditioner settings using the
DIP switches.
Failure to observe will lead to considerable damage!
Note!! The module calibrates itself, when using the DIP
switches on the printed circuit board to set the
temperature range.
20