Weidmüller WAVESERIES Thermo Select WTS4 Notice D'utilisation page 19

3 Mounting and dismounting
Warning!! Mounting and dismounting may only be carried out
when the power supply has be disconnected. Failure
to observe will lead to considerable damage!
3.1 Mounting onto TS 35 DIN rails
(Page 74, Fig. 1)
3.2 Pluggable electronic components for range alteration
(depending on model)
(Page 74, Fig. 2)
1. Remove connector, (depending on model either screw-type
or tension clamp).
2. Press locking clips on both sides of the enclosure.
3. Pull out the circuit board.
Warning!! The circuit board can only be inserted in one
position.
The connectors have been coded by the manufac-
turer, ensuring that they cannot be reversed.
19