Operation - Denon PMA-SA1 Mode D'emploi

ENGLISH

3 OPERATION

PREPARATION
1. CHECKING CONNECTIONS
• Make sure that all the connections are proper by referring
to the rear panel.
• Check the polarity (positive and negative) of connections,
and the directivity of stereo separation (right cord to right
channel terminal, and left cord to left channel terminal).
• Check the directivity of pin plug cord connection.
2. SETTING OF EACH KNOB
• Turn the VOLUME knob
position.
After checking the above items, turn on the power, the amplifier
is set in the ready mode in a few seconds.
PLAYING A RECORD
1. Set the EQ POWER switch
2. Set the INPUT SELECTOR switch
3. Operate the turntable and play the record.
4. Turn the VOLUME knob
PLAYING CD PLAYER
1. Set the INPUT SELECTOR switch
2. Operate the CD player.
3. Turn the VOLUME knob
PLAYING CD PLAYER
1. Set the INPUT SELECTOR switch
2. Operate the CD player.
3. Turn the VOLUME knob
RECEPTION OF RADIO PROGRAMS
1. Set the INPUT SELECTOR switch
2. Operate the tuner to receive a radio program.
3. Turn the VOLUME knob
PLAYING AUDIO EQUIPMENT CONNECTED TO
DVD/AUX TERMINALS
1. Set the INPUT SELECTOR switch
2. Operate the Audio equipment.
3. Turn the VOLUME knob
PLAYING AUDIO EQUIPMENT CONNECTED TO
BALANCED INPUT TERMINALS
1. Set the BALANCED INPUT switch
2. Operate the Audio equipment.
3. Turn the VOLUME knob
10
(Refer to page 5.)
t
counterclockwise, to minimum
e
to "ON".
i
to "PHONO".
t
to yield an appropriate volume.
i
to "CD-1".
t
to yield an appropriate volume.
i
to "CD-2".
t
to yield an appropriate volume.
i
to "TUNER".
t
to yield an appropriate volume.
i
to "DVD/AUX" position.
t
to yield an appropriate volume.
y
to "ON".
t
to yield an appropriate volume.
PLAY BACK WITH TAPE DECK
1. Set the INPUT SELECTOR switch
"TAPE-2/MD".
2. Operate the tape deck.
t
3. Turn the VOLUME knob to yield an appropriate volume .
RECORDING WITH TAPE DECK
1. Set the BALANCED INPUT switch
i
switch to the program source you wish to record.
2. Set the REC OUT SELECTOR switch
3. Play back the program source.
4. Start recording with the component connected to "TAPE-
1/CD-R" or "TAPE-2/MD".
COPYING FROM ONE TAPE TO ANOTHER
To copy from TAPE-1/CD-R to TAPE-2/MD, set the REC OUT
u
SELECTOR switch to "TAPE-1 1 2".
To copy from TAPE-2/MD to TAPE-1/CD-R, set the REC OUT
u
SELECTOR switch to "TAPE-2 1 1".
ENGLISH
i
to "TAPE-1/CD-R" or
y
and INPUT SELECTOR
u
to "SOURCE".