Appliance Description; Start-Up; Use; Care And Storage - Beurer FM 39 Mode D'emploi

Appareil de massage shiatsu des pieds
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 14
The device is only intended for the purpose described in these operating instructions. The manufacturer cannot
be held liable for damage occurring as a result of inappropriate or careless use.

5. Appliance description

Shiatsu foot massager
3

6. Start-up

• Remove the packaging.
• Check the device, power supply and cables for damage.
• Connect the device to the mains power supply.
• Route the cable safely so that there is no risk of anyone tripping over it.

7. Use

When seated comfortably place your feet on the two platforms.
prevent it from sliding.
Switch on the massager with the ( ) button. Press the ( ) button again to activate the heat function. Press the
( ) button repeatedly to switch the device off.
The massage must be pleasant and relaxing at all times. Stop the massage or change your position or the contact
pressure if you find it is painful or unpleasant.
Note
• Do not use the massage device for longer than 15 minutes. Otherwise, using the device for longer can
over-stimulate the muscles and cause tension instead of relaxation.
Massage of a specific point on the sole of the foot may influence the corresponding organ of the body.
However, we recommend studying relevant literature and asking your doctor before using point reflex
zone massage to achieve the desired effect.

8. Care and storage

Cleaning
WARNING
• Disconnect the device before cleaning it.
• Only clean the appliance in the manner specified. Fluid must never be allowed to enter into the device
or accessories.
• Clean the device with a slightly damp cloth. If it is very dirty, you can also moisten the cloth with a
mild soapy solution.
• Small marks can be removed using a cloth or damp sponge, and some liquid delicate laundry detergent
where necessary. Do not use any solvent-based cleaning products.
• Do not use the device again until it is completely dry.
1
2
1. Platform with 3 massage heads that rotate in
opposite directions.
2. Button ( )
Press 1x: Shiatsu massage
Press 2x: activates the heat function
Press 3x: off
3. Mains plug
The rubber feet on the base of the unit
11

Publicité

Table des Matières
loading

Table des Matières