Repeat Playback; Program Playback - Technics SU-R1 Manuel D'utilisation

∫ Random repeat playback
Press [RND].
Each time you press the button:
All tracks in a folder are repeated
On
randomly.
≥ "RND `" is displayed.
Off Turns off random repeat mode.

∫ Repeat playback

Press [`].
Each time you press the button:
Only plays the selected track.
1-Track
≥ "1 `" is displayed.
All tracks in a folder are repeated.
All
≥ "`" is displayed.
Off Turns off repeat mode.
≥ You cannot use random repeat playback in combination with other
playback modes.
≥ You can use repeat playback in combination with program
playback.
18
(18)

Program playback

This function allows you to program up to 24 tracks.
Preparation
≥ It is not possible to program tracks by moving folders.
Move all the tracks you want to program to a single folder
in advance.
1
Press [PGM] in the stop mode.
≥ "Program Mode" screen will be displayed.
2
Press [OK] to display the programming
screen.
3
Press [3, 4] to select the desired track.
4
Press [OK].
≥ Do steps 3 through 4 again to program other tracks.
5
Press [1/;] to start playback.
≥ To return to the "Program Mode" screen, press [∫].
Operations on the remote control
Press [∫].
Stop
≥ Programed content is maintained.
Check the Press [2, 1] in the stop mode.
≥ To return to the "Program Mode" screen,
programed
press [RETURN].
order
Add tracks Do steps 3 through 4 in the stop mode.
Press [CLEAR] in the stop mode.
Clear the last
≥ It is not possible to select and clear the
track
desired programed track.
1 Press [PGM] in the stop mode.
≥ "Program Clear" is shown.
Cancel
2 Press [3, 4] to select "Yes" and
program mode
then press [OK].
≥ The program memory will be cleared.
≥ Programed content is maintained as long as the input source is set
to "USB".
≥ The program memory will be cleared:
– When the USB device is disconnected.
– When the unit is turned to standby or off mode.
≥ You can use program playback in combination with repeat
playback.