Technics SU-R1 Manuel D'utilisation page 12

AC power supply cord connection
Connect only after all other connections are completed.
This unit
(rear)
∫ To disconnect the AC power supply cord from this unit
Pull out the AC power supply cord while pressing the top and bottom sides of the connector.
≥ Although the AC power switch is in the [
main electrical outlet if you will not be using the unit for an extended period of time. Place the unit so the plug can be easily removed.
Measuring the characteristics of the amplifier and correcting its
output
If the SE-R1 is connected to this unit via the system control function, you can operate using the remote control of this unit.
Press and hold [LAPC] until the LAPC indicator on the SE-R1 starts to blink.
≥ The SE-R1 will start measuring the characteristics of the amplifier if it is connected to the speakers.
≥ For information on the operations of the SE-R1, please also refer to its operating instructions.
12
(12)
DO
] position, the unit is not completely disconnected from the mains. Remove the plug from the
DO NOT
To a household AC outlet
AC power supply cord
(supplied)


