Mesto 3270FO Mode D'emploi page 17

GB IRL
Fault
The nozzle does not spray
even though pressure is
present.
The shut-off valve does not
close.
Liquid emerges without the
lever being activated.
No foam formation.
Contact address for additional information → Title page.
Warranty
We guarantee that from the time it is first purchased for a period of the legally valid requi-
red warranty period (maximum 3 years) this device will not exhibit any material or proces-
sing errors. If defects are discovered during the warranty period, MESTO or the distributor
in your country will repair the device without charging for the labor or material or (at the
discretion of MESTO) replace the device itself or its defective parts.
If such defects are discovered, please contact us immediately. We require the invoice or
cash register receipt for purchase of the device.
The warranty does not include wearing parts (seals, O-rings, diaphragm, etc.) or defects,
which have occurred due to improper use or unforeseeable circumstances.
CE Declaration of Conformity
In accordance with EC Directive 2006/42/EC, Annex II, No. 1A.
We,
MESTO Spritzenfabrik Ernst Stockburger GmbH
Ludwigsburger Straße 71
D-71691 Freiberg
declare under our sole responsibility that the Series 3270 foaming devices as supplied
meet all the relevant requirements of Directive 2006/42/EC of the EU. Furthermore the
devices correspond to Directive 2014/68/EU for Pressure Equipment.
Rolf Rehkugler is authorized to compile the technical documentation.
Freiberg, 06.12.2016
0517
AUS USA
Cause
Filter [16, 26] (Fig. 20,
20b) or/and nozzle [14]
or/and mixing plates [15]
(Fig. 19) are clogged.
O-rings [17] of the pressu-
re bolt [18] not greased /
lubricated. (Fig. 22)
Defective pressure bolt
[18] or O-rings [17].
(Fig. 22)
Riser pipe [8] separated
from hose line.
Position riser pipe [8] not
correct. (Fig. 4)
Bernd Stockburger
Managing Director
Original operating instructions
17
NZ CDN
Remedy
Clean the filter or / and nozzle.
Replace mixer plates.
Grease the O-rings of the pres-
sure bolt
Replace the pressure bolt or
O-rings.
Connect riser pipe/hose line.
Screw the hose line [3] into the
tank again.
IND
6993470